Atlas' Moisture Tolerant Products
5 Oct 2011
MOISTURE TOLERANT PRODUCTS
ATLAS® GC PRIMER - REZKLAD® E-CONCRETE PRIMER MT - RED FURNANE® SETTING BED MT
Moisture in concrete, it is always a factor. Whether it is a new pour or an existing slab, it seems to be a problem on most jobs.
Not any more. ATLAS has developed a series of products to eliminate the concern.
ATLAS® GC PRIMER
Can be used on “GREEN CONCRETE” and existing concrete.
Is a primer, primer sealer or concrete curing compound.
Meets ASCM C309 requirements for use as a concrete curing compound.
Can be applied to concrete without any surface preparation up to 36 hours after finishing (after 36 hours grit blasting is required).
Does not need to be removed prior to further treatment.
Can be brush, roller or spray applied.
Is compatible with all ATLAS epoxy setting beds, coatings, linings, and floor topping systems.
REZKLAD® E-CONCRETE PRIMER MT
Can be used on new concrete after 5 days cure time.
Can be used on existing damp concrete, simply remove standing water.
Can be brush or roller applied.
Requires grit blasting or acid washing surface prep in order to achieve a tenacious bond.
Is a primer compatible with all ATLAS epoxy setting beds, coatings, linings, and floor topping systems.
RED FURNANE® SETTING BED MT
Is a trowel applied setting bed or bond coat for floor tile, pavers and brick.
Can be used on new concrete after 5 days cure time.
Can be used on existing damp concrete, simply remove standing water.
When struck with a hammer and chisel, Red Furnane® Setting Bed MT “pulls concrete”,
demonstrating the outstanding bond achieved even to damp concrete.
Technical Data Sheets on all three products are
available at www.atlasmin.com
Atlas Minerals & Chemicals, Inc.
Mertztown, PA 19539 • E-mail: sales@atlasmin.com
Jack May / Atlas
|